WS2812B-LED-RC-Controller/nfc01.ino

86 lines
1.9 KiB
Arduino
Raw Permalink Normal View History

2017-07-16 16:09:18 +02:00
#include "FastLED.h"
int rc01 = 9;
int rc02 = 10;
int led_spotlight = 2;
int rc01Val = 0;
int rc02Val = 0;
int modus = 0;
int modusMax = 13;
int red = 0;
int green = 0;
int blue = 0;
int randomVal = 0;
#define DATA_PIN 3
#define LED_TYPE WS2812B
#define COLOR_ORDER GRB
#define NUM_LEDS 44
CRGB leds[NUM_LEDS];
#define BRIGHTNESS 255
#define FRAMES_PER_SECOND 60
#define ARRAY_SIZE(A) (sizeof(A) / sizeof((A)[0]))
boolean pullRC = true;
void setup() {
//Serial.begin(9600);
Serial.println("_-_-_- Night Fly Controller V01 _-_-_-");
pinMode(rc01, INPUT);
pinMode(rc02, INPUT);
pinMode(led_spotlight, OUTPUT);
pinMode(LED_BUILTIN, OUTPUT);
digitalWrite(LED_BUILTIN, HIGH);
delay(3000); // 3 second delay for recovery
// tell FastLED about the LED strip configuration
FastLED.addLeds<LED_TYPE, DATA_PIN, COLOR_ORDER>(leds, NUM_LEDS).setCorrection(TypicalLEDStrip);
// set master brightness control
FastLED.setBrightness(BRIGHTNESS);
}
// List of patterns to cycle through. Each is defined as a separate function below.
typedef void (*SimplePatternList[])();
SimplePatternList gPatterns = { blackMode, redMode, blueMode, greenMode, whiteMode, rainbow, rainbowWithGlitter, confetti, sinelon, bpm, navigation, chase, chaseRGB, randomMode };
uint8_t gHue = 0; // rotating "base color" used by many of the patterns
void loop() {
if (getRC01()) {
digitalWrite(led_spotlight, HIGH);
} else {
digitalWrite(led_spotlight, LOW);
}
setModus();
}
void setModus(){
if (getRC02()) {
modus = modus + 1;
if (modus > modusMax) {
modus = 1;
}
}
Serial.println(modus);
serialPrintModus(modus);
gPatterns[modus]();
// send the 'leds' array out to the actual LED strip
FastLED.show();
// insert a delay to keep the framerate modest
FastLED.delay(1000 / FRAMES_PER_SECOND);
// do some periodic updates
EVERY_N_MILLISECONDS( 20 ) {
gHue++; // slowly cycle the "base color" through the rainbow
}
}