Disable unused peripherals for power saving

main.c

@@ -46,6 +46,7 @@ volatile eMode eModeCurrent = ANIMATION_BLINK;
 // Forward declarations
 ISR(PORTA_PORT_vect);
 static void software_reset(void);
+static void configureLowPower(void);
 void initPWM(void);
 void setPWM_PA2(uint8_t duty);
 static inline void leds_off(void);
@@ -62,6 +63,10 @@ void ledStaticFull(void);
  */
 int main(void)
 {
+
+    // Disable unused peripherals for power saving
+    configureLowPower();
+
     // Configure LED pins as outputs
     VPORTA.DIR = (PA1_SET_MASK | PA2_SET_MASK | PA3_SET_MASK | PA6_SET_MASK | PA7_SET_MASK);
     initPWM();
@@ -152,6 +157,54 @@ static inline void switchMode(void)
     eModeCurrent = (eModeCurrent + 1) % MAX_COUNT;
 }
 
+/**
+ * @brief Configure for lowest power consumption
+ */
+static void configureLowPower(void)
+{
+    // Set unused pins as outputs LOW to prevent floating inputs
+    // Floating inputs can cause extra current consumption
+    PORTA.DIRSET = PIN4_bm | PIN5_bm; // Set PA4, PA5 as outputs if unused
+    PORTA.OUTCLR = PIN4_bm | PIN5_bm; // Drive them LOW
+
+    // Configure sleep mode
+    set_sleep_mode(SLEEP_MODE_IDLE); // Use IDLE when TCA0 PWM needs to run
+    // Use SLEEP_MODE_STANDBY for deep sleep when LEDs are off
+
+    // Disable unused timers
+    TCB0.CTRLA = 0; // Disable TCB0 if not used
+    // TCA0 is used for PWM, keep it enabled
+
+    // Disable ADC (Analog-to-Digital Converter)
+    ADC0.CTRLA &= ~ADC_ENABLE_bm;
+
+    // Disable AC (Analog Comparator)
+    AC0.CTRLA &= ~AC_ENABLE_bm;
+
+    // Disable unused USART
+    USART0.CTRLB = 0;
+
+    // Disable TWI (I2C) if not used
+    TWI0.MCTRLA = 0;
+    TWI0.SCTRLA = 0;
+
+    // Disable SPI
+    SPI0.CTRLA = 0;
+
+    // Disable Watchdog Timer (if not needed)
+    // Note: WDT can only be disabled during first 4 clock cycles after reset
+    // CCP = CCP_IOREG_gc;
+    // WDT.CTRLA = 0;
+
+    // Disable BOD (Brown-Out Detection) in sleep modes for lower power
+    // This is done via fuses, not runtime configurable
+
+    // Disable digital input buffers on unused pins to save power
+    // Only needed if pins are truly unused (floating)
+    // PORTA.PIN4CTRL = PORT_ISC_INPUT_DISABLE_gc;  // PA4 if unused
+    // PORTA.PIN5CTRL = PORT_ISC_INPUT_DISABLE_gc;  // PA5 if unused
+}
+
 /**
  * @brief Init PWM for PA2
  */